&Roll Swivel Housing ReplacementUpdated a month ago

REPAIR GUIDE

Use this guide to replace the swivel housings on your &Roll frame

UPDATED NOV 2024

Required Tools

• #2 Philips head screwdriver

Required Replacement parts

• &Roll Swivel Housing Service Kit

Notice

To make the repair easier position your stroller frame as shown and remove the swivel wheels. 

Procedure

/01:  Remove the swivel lock button by inserting the screw driver through the wheel hole on the bottom and pushing it out. The button should pop off the top side and a spring will likely fall out as well, keep these aside for later.

/02:  Remove the 4 screws securing the swivel housing, then remove the swivel housing which should easily slide out.

/03:  Insert the new swivel housing being mindful of the orientation of the lock button. 

/04:  Re-install the 4 screws.

/05:  Re-install the top button. First install the spring on the button and press the two into the frame being mindful of the orientation. The shallower end should be on the front side of the stroller.